when shipping a dangerous when wet material placarding is required
(a) Capacity of 640 cubic feet or more. The following packagings may be placarded on only two opposite sides or, alternatively, may be labeled instead of placarded in accordance with subpart E of this part: (1) A portable tank having a capacity of less than 3,785 L (1000 gallons); (2) A DOT 106 or 110 multi-unit tank car tank; (3) A bulk packaging other than a portable tank, cargo tank, flexible bulk container, or tank car (e.g., a bulk bag or box) with a volumetric capacity of less than 18 cubic meters (640 cubic feet); (4) An IBC. For Federal Register citations affecting 172.513, see the List of CFR Sections Affected, which appears in the Finding Aids section of the printed volume and at www.govinfo.gov. 172127, 59 FR 49133, Sept. 26, 1994; Amdt. It is important to remember that except for materials in the U. N. Recommendations, the ICAO Technical Instructions, or the IMDG Code, a material that is not a hazardous material according to this sub-chapter may not be offered for transportation or transported when its description on a shipping paper includes a hazard class or an identification number specified in 49 CFR 172.101. HAZARDOUS MATERIALS SHIPPER AREAS. The cookie is used to store the user consent for the cookies in the category "Analytics". 1 When shipping a Dangerous When Wet material placarding is required? Employees must receive the required training every three years or any time there is a change in job function. For the purposes of paragraphs (g)(1) through (g)(4), there is a distinction between the phrases explosive articles and explosive substances. (2) The placarding exception provided in 172.504(c) applies to each freight container and aircraft unit load device being transported for delivery to a consignee immediately following an air or water shipment, and. This content is from the eCFR and may include recent changes applied to the CFR. ); (2) Be located clear of appurtenances and devices such as ladders, pipes, doors, and tarpaulins; (3) So far as practicable, be located so that dirt or water is not directed to it from the wheels of the transport vehicle; (4) Be located away from any marking (such as advertising) that could substantially reduce its effectiveness, and in any case at least 3 inches (76.0 mm.) (3) Hazardous materials prepared in accordance with 173.13 of this subchapter; (4) Hazardous materials which are packaged as small quantities under the provisions of 173.4, 173.4a, 173.4b of this subchapter; and. contact the publishing agency. Round tubes or overpacks are not accepted. [Amdt. DIVISION 4.2 SPONTANEOUSLY COMBUSTIBLE MATERIAL DIVISION 4.3 DANGEROUS WHEN WET. A written report shall be submitted on DOT Form F 5800.1 for all incidents involving the transportation of hazardous materials unless excepted. (2) Each material must be packaged in the manufacturer's original packaging, or a packaging of equal or greater strength and integrity. This document provides only a general overview of the requirements for transporting hazardous materials by highway. It is the hazmat employer's responsibility to determine the adequacy of the training being presented. The eCFR is displayed with paragraphs split and indented to follow Agricultural Operations The Government Printing Office has made the Federal Register and 49 CFR available on the Internet. (1) Is sufficiently cleaned of residue and purged of vapors to remove any potential hazard; (2) Is refilled, with a material requiring different placards or no placards, to such an extent that any residue remaining in the packaging is no longer hazardous; or. Choosing an item from is aggregate gross weight. DIVISION 4.2 SPONTANEOUSLY COMBUSTIBLE MATERIAL DIVISION 4.3 PRECARIOUS WHEN WET. (2) Any sign, advertisement, slogan (such as Drive Safely), or device that, by its color, design, shape or content, could be confused with any placard prescribed in this subpart. DOD and Service Regulations also require compliance with 49 CFR Parts 100-180. Air service level shipments of Class 1 explosives prepared under LimitedQuantity provisions in 49 CFR173.63(b) will not be accepted with aground Limited Quantity mark. site when drafting amendatory language for Federal regulations: "Dangerous when wet" material means a material that, by contact with water, is liable to become spontaneously flammable. UPS. HAZARDOUS MATERIALS SHIPPER RESPONSIBILITIES, Listed above are the major responsibilities of HM shippers. The shipper must complete all requirements for a hazardous materials shipment before pickup. (c) Exceptions. The manufacture, fabrication, marking, maintenance, reconditioning, repairing or testing of a package or container which is represented, marked, certified or sold for use in the transportation of hazardous materials (49 CFR 171.1(a)), An agency or political subdivision of a State. (3) Placarding is not required on a freight container or aircraft unit load device if it is only transported by air and is identified as containing a hazardous material in the manner provided in part 7, chapter 2, section 2.8, of the ICAO Technical Instructions (IBR, see 171.7 of this subchapter). All hazmat employees must have this training. 172123, 56 FR 66264, Dec. 20, 1991, as amended at 57 FR 45460, Oct. 1, 1992]. material having the same proper shipping name and identification number loaded at one 172123, 55 FR 52599, Dec. 21, 1990, as amended at 56 FR 66259, Dec. 20, 1991; Amdt. The division numeral, 1.6, must measure at least 64 mm (2.5 inches) in height. Hazardous materials packages should be secured in a transport vehicle to prevent damage during transportation. DIVISION 4.3 DANGEROUS WHEN WET, CLASS 5 OXIDIZING SUBSTANCES; ORGANIC PEROXIDES, DIVISION 5.1 OXIDIZER The CFR Rules Regarding Placarding | Hazmat University - News and Info The phone number must be to someone capable of providing information on the material. (d) A flexible bulk container may be placarded in two opposing positions. May be marked in a different location. formatting. Applicability of placarding requirements 172.500: Placarding is not required fork catching substances, ORM . Except as provided in paragraph (b) of this section, no person may affix or display on a packaging, freight container, unit load device, motor vehicle or rail car, (1) Any placard described in this subpart unless. However, many states require military movements by highway to conform to 49 CFR or compatible state regulations. . Bulk packaging requirements are in section 172.302. It is from the proper identification of the hazardous materials that the other requirements are based on.
